On Scour's Frontier
Combing both computer and physical model studies, engineers attempted to assess the scour of a new North Carolina bridge that will bear the brunt of the East coast's worst...
Design of Blast Resistant Buildings in Petrochemical Facilities
This report provides general guidelines in the structural design of blast resistant petrochemical facilities. Informational coverage is provided for OSHA requirements, design objectives,...
Design of Hydraulic Steel Structures
Technical Engineering and Design Guides, as adapted from the U.S. Army Corps of Engineers, No. 22 This manual prescribes guidance for designing hydraulic...
Guidelines for Seismic Evaluation and Design of Petrochemical Facilities
These guidelines are intended to provide practical recommendations on several areas which affect the safety of a petrochemical facility during and following an earthquake. In the area...
Wind Loads and Anchor Bolt Design for Petrochemical Facilities
Current codes and standards do not address many of the structures found in the petrochemical industry. Therefore, many engineers and companies involved in the industry have independently...
Design/Build Insurance: Filling in the Gaps
Design-build is on a roll, and the insurance industry is helping it roll along faster. Since 1987, the domestic volume of design-build construction has climbed from 6 billion to 56 billion...
Rubber Meets the Road in Maine
Maine design engineers working on a $42 million highway project, faced several settlement problems in the alignment's soft soil. One of their solutions was to use 500,000...
Structural Design of Closure Structures for Local Flood Protection Projects
Technical Engineering and Design Guides, as adapted from the U.S. Army Corps of Engineers, No. 21 This guide provides a framework for the structural...
Waterpower '97
This proceedings consists of papers presented at the Waterpower '97 specialty conference. This international conference on hydropower was held in Atlanta, Georgia, August...
Aircraft/Pavement Technology
In the Midst of Change
This proceedings,
Seismic in St. Louis
Following collapse of sections of the double-deck I-880 Cypress Viaduct in the 1989 Loma Prieta earthquake, the Missouri Department of Transportation initiated a seismic evaluation and...
Scandinavia's International Connection (Available only in Structural Engineering Special Issue)
The 7.8-km-long cable-stayed �resund Bridge, the centerpiece of the first road and rail link between Scandinavia and Europe, is the third and final link of the 15.8 km Oresund Link. The...
Innovative Design and Construction for Foundations and Substructures Subject to Freezing and Frost
This proceedings,
An Evaluation of Laboratory Test Results for the U.S. Gypsum Sight and Sound Screen System
The highway innovative Technology Evaluation Center (HITEC) serves as a clearinghouse for implementing highway innovation by providing nationally focused, collaborative evaluations of...
Seismic Analysis and Design for Soil-Pile-Structure Interactions
Pile foundations are used extensively to support structures in seismic regions around the world. For years, geotechnical engineers have neglected to consider the interaction soil-pile...
Design/Build Meets Hazardous Waste
For all types of design/build projects, a close cooperative relationship is required among the various stakeholders involved in the project. For hazardous waste cleanup design/build projects,...
The Right Tooele for the Job
Parker describes how the nation's largest chemical munitions destruction facility was designed and how it will operate. The U.S. Signed on to the Chemical Weapons Convention...
Saving the Bluffs: Engineering at the Edge
Erosion and landslides along the bluffs bordering the Mississippi River in Natchez, Miss. became an emergency situation when the only road to residents below the bluff was cut off from...
Florida's Big Bellies
FPL designed and installed double reverse tapered poles, affectionately called big belly because the width gradually increases toward the middle and narrows at both ends. The poles replace...
Factories for the Information Age
As the demand for computer chips continues to soar, designers of microelectronics manufacturing facilities must keep pace with exacting building requirements. Successful projects require...
Return to search